• Select B (cutter) from [TOOL SELECT], and check [Adjustment of offset] under Select a tool.

1. Select a tool [B (cutter)].

　 For details, see “SELECTING A TOOL [TOOL SELECT]” in Operation Manual.


2. Go to Adjustment of offset ([TOOL ADJUST]) and use a pen to adjust the cutter
　 in right position.
　 Attach a pen on the head A and a cutter on the head B respectively, and then
　 perform “Adjustment of the offset”.

　 For details, see “Adjustment of the offset” in Operation Manual.

---

---

3. Check also Adjustment of the eccentricity and Adjustment of θ angle.

　 For details, see “Adjustment of the eccentricity” and “Adjustment of θ angle”
　 in Operation Manual.


4. Check again Adjustment of offset, and then check re-plotting.

---