• Please see followings.

[For UJF-3042 / UJF-3042FX]

Note that, when using thin substrates (such as paper or film), the marks of vacuum
holes on the board surface may remain after printing. Be sure to perform a prior
test on substrates before using it.

[For UJF-3042HG]

When you print on thin substrates (such as paper or film), install the accompanying
vacuum table and the table spacers, and adjust the height of the table to achieve a
head gap of 1.5mm(recommended value).
In addition, note that the marks of vacuum holes on the board surface may remain
after printing. Be sure to perform a prior test on substrate before using it.

For the vacuum table and the table spacers,
see "Q: How can the head gap be adjusted?"

---