1. Detect register marks.

How to adjust the cut misalignment for the data with register mark

If you are concerned about misalignment when cutting data with register mark, make the following adjustments.

  1. Set the Detection mode setting [DETECT MODE] value to Precision(PREC).Detection mode setting [DETECT MODE]
  1. Adjust the setting value of Sensor sensitivity setting [SENSOR LEVEL]. Depending on the media used, blur condition of register mark print, etc., misalignment may be improved by adjusting the sensor sensitivity.Sensor sensitivity setting [SENSOR LEVEL]
  1. Adjust the register mark sensor positions. Aligning the Register Mark Sensor Position
  • After adjusting the sensor sensitivity, be sure to align register mark sensor.