2. Helpful Tips
3. Jog Mode Functions
4. Cut Area Setting [CUT AREA]

1. Jog Mode Functions

Cut Area Setting [CUT AREA]

The cut area is set by the range extending from the origin to the diagonally opposite UL (upper left) point set by the user. Set the UL point position here.
Repeating sheet detection will clear the cut area.

1. Press the [REMOTE] key to select local mode.

• Press the [REMOTE] key to confirm beforehand that cutting (printing) is not performed even in remote mode.

2. Use to select jog mode.

3. Press the [FEED] key.

4. Use to set the UL point.

5. Press the [ENTER/HOLD] key to confirm the UL point.

• The "CUT AREA *.* *.*" screen appears for a short time, before the machine reverts to local mode.

• Set the UL point in the positive direction from the origin.
• Set the origin within the cut area. An operation error will occur if it is set outside the cut area. Note about the cutting area