1. Feed Settings [FEED OPTION]

FEED OFFSET Setting

This enables slightly more sheet to be fed when feeding the sheet such as with pre-feed.
This ensures sufficient slack as required when cutting (or printing).

If only a little amount of sheet remains on the roll, the roll sheet may be wound back on to the roll by the vibration occurring during operation, leaving insufficient slack and preventing accurate cutting (or printing). Feeding slightly more sheet minimizes such issues.

  • The settings are retained even when the power is turned off.
  • The [FEED OFFSET] setting is disabled when [OVER FEED] is set.
  1. Press the [FUNCTION] key in local mode.
  1. Use updown jog_ to select [SET UP], then press the [ENTER/HOLD] key.
  1. Use updown jog_ to select [FEED OPTION], then press the [ENTER/HOLD] key.
  1. Use updown jog_ to select [FEED OFFSET], then press the [ENTER/HOLD] key.
  1. Use updown jog_ to select the offset, then press the [ENTER/HOLD] key.
  • Setting: 0 to 100cm
  1. Press the [END] key several times to exit.