Register Mark Detection Precautions

To ensure the distance between register marks is the same as the cutting length, enter the distance between printed register marks when they are detected. Scale compensation setting [DIST.REVI.]
In this case, the distance correction is disabled, and register mark spacing scale correction takes precedence.
Subsequently altering the distance correction function value disables the register mark spacing scale correction.
The sheet tilt correction, register mark spacing scale correction, and origin position will be cleared if the clamp lever is pushed to the rear and the sheet removed.
The origin is set at TP1 (position at center of corner lines) when a register mark is detected.
Using the jog keys to set the origin to another position enables that origin.
Position the register marks to form a rectangle when the four points are linked.
Cutting offset may result if the marks are arranged unevenly.
If the rotation function was set, this will be automatically disabled.